Red light center mac
![red light center mac red light center mac](http://www.thetreefarm.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/f/i/file_111_98.jpg)
Use wire nuts to connect the neutral and ground wires on the Treatlife Light Switch to the labeled wires coming from the wall in order. Remove the sticker securing the wires on the new switch. Loosen the screw terminals and remove the old switch.
![red light center mac red light center mac](https://www.eclipse.org/sumo/images/screenshots/screenshot2.png)
Note: Make sure all of the text on the labels in the pictures is clearly displayed. Take one or two pictures of the old switch and where each wire is connected to it, in case you need guidance to repeat the installation. L Label the remaining two wires with the “Traveler" stickers in the package. L Label the LINE/LOAD wire (usually BLACK, attached with a black screw, and may be labeled “common".) in the wall with the “Line/Load” sticker. L Label the remaining two wires in the wall with the two “ Line/Load ” stickers in the package. Note: The wires may be different colors than shown. GROUND wires are usually BARE COPPER or GREEN. L Label the NEUTRAL and GROUND wire in the wall with the stickers in the package. If necessary, shut off additional circuits until no voltage is found.
![red light center mac red light center mac](https://i.pinimg.com/736x/4a/c9/02/4ac9025e006c4ed24892d730d23a0809.jpg)
Make sure there is no power on the neutral wires from a neighboring circuit. Note: If there is no neutral, please try another location or call an electrician for help. Unless you are replacing an existing smart switch, it’s probably not connected to your old switch. Make sure there are NEUTRAL wires (most likely a bundle of one or more white wires ) in the wall.
#Red light center mac install#
Screw the 4-way switch back to the wall, and unscrew one of the other two 3-way switches on the circuit that controls the same light.Ī neutral is required to install the smart light switch.
![red light center mac red light center mac](https://media.wired.com/photos/617c8f35f73e5f88a92c70ca/master/pass/Gear-Macbook-Pro-21-top-Art.jpg)
If three switches control the same light or the same bundle of lights, one of the switches is a 4-way switch. Two switches control the same light or the same bundle of lights. Only one switch controls one light or a bundle of lights. Unscrew the old switch and pull it out of the wall. You may need to turn off more than one circuit breaker. We recommend you to remove the faceplate from the old switch and use electrical tester to test all wires connected to the switch to ensure there is no voltage in the circuit. If a light turns on, return the panel to turn off the correct circuit. Press each light switch at the location you’re doing the installation to confirm power is off.
#Red light center mac professional#
Please call a professional electrician if you are not familiar with electrical work. Make sure the power to every switch you are replacing has been turned off before installation. Locate your circuit breaker panel and turn off the power to each switch you are replacing L The supported maximum wattage rating is: 1250W. L Keep your mobile device close to the Treatlife light switch until setup is complete. L Install your Treatlife where you have a strong Wi-Fi signal. Please try another location or call an electrician for help. If your house was built or remodeled before mid-80's, you may not have a neutral. L Neutral wire is required to install the smart switch.
#Red light center mac free#
Feel free to install the remaining 3-way switches in different locations. L If you purchased a 3-way bundle, you only need to install one of them per circuit. L The Treatlife 3-way light switch can replace existing 3-way or single-pole light switches.